The most common method to change the views is using the many zoom options of the program, which increase and decrease the size of the image displayed in the drawing area.

 

Window Zoom

---

Using Window Zoom you can quickly zoom approaching an area by specifying the angles that define it. The region specified by the selected angles is centered in the new view in case it doesn't exactly match the aspect ratio of the zoomed window. The command can also be activated from the Standard toolbar.

 

Dynamic Zoom

---

Zooms interactively using an extension of the drawing. During the dynamic zoom the cursor turns into a magnifying glass with the plus (+) and minus (-) signs. While holding down the select button at the center point of the window and moving vertically towards the top of the window, it is applied a zoom factor of 100%. On the contrary, by holding down the select button at the center point of the window and moving vertically towards the bottom of the window, it is applied a zoom out factor of 100%. When the select button is released, the zooming stops. The command can also be activated from the Standard toolbar.

 

Previous Zoom

---

Activates the view immediately preceding the current one. The command can also be activated from the Standard toolbar.

 

Zoom All

---

Returns the full view of the project work within the drawing area.

 

 

 

In Drawing settings the user can set the display data in the grid, the tolerance of the cursor etc.

 

 

©  GeoStru Software